The Smartest DIYers Know to Avoid These 6 Amateur Mistakes

The savings. The personal satisfaction. The increased resale value. Taking on your own kitchen remodel  can deliver countless financial and emotional perks, if done right. But done wrong, yikes! Poor-quality workmanship can easily decrease a home's value, earn your bragging rights and keep your home's value intact (and rising) by avoiding these telltale signs of DIY gone wrong:

#1 Gaps Around Cabinetry

Why it happens: Because homes aren't perfectly level. And when you hang cabinets to be level (which you should), that leaves gaps next to the wall.

How the pros do it: For a finished look, you have to go the extra mile, Fill the gap with wood shims. (If you've ever wedged anything under a table leg to stop it from rocking, you've used a shim. The same technique works here, except you can actually buy ones that work better than a folded napkin.) Then cover the shims with the same molding used in the rest of the room.

#2 Misplaced Light Fixtures

Why it happens: Whenever light fixtures don't line up over a sink or a kitchen island, that indicates a DIY job that wasn't well planned or often forget about lighting, or don't think about it soon enough to budget for it, then end up having to live with the old lighting.

#3 Cracked Floor Tiles

Why it happens: Usually because the subfloor is uneven or the underlayment is wrong. If the subfloor is uneven, or has too much "give," it leaves room for the rigid tile to crack and shift.

How the pros do it: They test to make sure the subfloor is level, then secure it to the floor joists, and then (this is crucial) install the appropriate underlayment for your specific tile type, such as a liquid one in the case of concrete or porcelain tile. Your tile supplier can help you figure that out. The key is to do it. It helps cushion against any unevenness that may happen as you use the floor.

#4 Sloppy Paint

Why it happens: Because inexperienced painters usually try to take shortcuts. Uneven transitions, paint on light switches, thinly veiled cracks, dents, and bumps. All are marks of a paint job that lacked proper preparation and cleanup.

How the pros do it: They spend more time prepping than they do actually painting:

  • Repairing wall surfaces

  • Removing outlet covers

  • Covering light fixtures with plastic wrap

  • Use masking tape to cover hardware

  • Using painter's tape along the ceiling and molding

To get clean lines around the ceiling and molding, remove painter's tape before water-based paint has dried completely, then go back and touch-up any smudges.

#5 Poorly Spaced Tile

Why it happens: There's a good chance the design wasn't fully planned prior to ordering materials or beginning installation. Grout-filled gaps and oddly pieced-together tiles, whether on the edge of a backsplash or in a corner of the floor, are dead giveaways of novice work,

How the pros do it: Use grid paper to make sure the design covers all bases: include all obstacles, whether they be electrical outlets or door frames. Then, use this model to lay out your tile design, starting in the center. Then double-check your calculations and do a test run in an inconspicuous spot.

#6 Gaps Between the Floor and the Wall

Why it happens: The baseboard or shoe molding probably wasn't removed before adding the new floor, making it impossible to not have a gap, even if it's just a tiny one.

How the pros do it: Always remove any molding. Install new flooring so that it gets as close to your walls or cabinets as recommended by the manufacturer. Then install a baseboard or shoe molding to cover the wall and floor's meeting place.

When you are thinking of doing a remodel yourself, take your time .Slow and steady wins the race. Take pride in the work you do and you will get years of enjoyment out of the space you created.

We would love to help you find that perfect place.